菜单
  
    摘要本篇设计所谈到的设计是污水处理厂打算建在上海市区的东北角,其主要目的是接收虹口港和杨浦港地区的污水。拟建成的污水厂进水水质如下:
    计划日处理污水量为50万吨左右,进水CODcr:250mg/L;BOD5:120mg/L;SS:150mg/L;TN:38mg/L;NH3-N :25mg/L;TP:4mg/L。
    通过对各个生物法处理的工艺研究结果来相比较,并决心用A/O法与活性污泥法相加在一起的处理工序,才能够达到利用较低的成本来达到脱氮和降解有机物质的目的。具体的方法是利用传统的活性污泥法来解决七成的污水,而另外三成的污水通过A/O工序技术进行处理。
    本篇设计的工艺流程大概如下文所描述,利用格栅来拦截比较大的漂浮物体;用旋流沉砂池从污水中分离那些相比之下密度比较大的无机颗粒,避免影响后续处理污水的运行,旋流沉砂池同样也是是利用水力涡流,让泥沙和有机物两者分开,加速砂粒的沉淀性;用 A/O和活性污泥曝气池合建的生物池来脱氮除磷,并降解废水中的有机污染物体;采用平流式沉淀池将曝气后的混和液进行泥水的分离,来保证最后处理过的水质;用污泥浓缩池来降低剩余的污泥含水比率,得以减少污泥本身的体积和降低污泥的外运输费用。
    用确定好的工艺流程,本篇设计之设计是利用对各种构筑物(包括格栅、旋流沉砂池、A/O生物池、平流式沉淀池、污泥浓缩池)的主要尺寸来设计计算管道直径,完成工序说明书、工艺流程图(含高层布置)、厂区平面图和主体构筑物单体图的设计。21956
    本工程投资费用大概为一亿八千万左右,在技术上有可行性,在经济上也有合理性。该工序运行的管理方法较为简单,自动化较高,运行治理的费用也比较较低,污水处理费每立方米仅用两毛五;整个工艺流程它的特点是:投资合理、运行较稳定、再次污染少、处理效果好、能耗低等等优点,并且达到国家尾水排放的标准。
    废水经处理后,CODcr≤100mg/L;BOD5≤30mg/L;SS≤30mg/L; NH3-N≤5mg/L;TP≤3mg/L。满足《城镇污水处理厂污染物排放标准》所规定的二级排放标准,预计年削减COD5量为:27375吨,年削减BOD5量为:16425吨。使被污染后的水质得到很大的改善,从而达到消除污染、实现环境保护、造福人类的目的。
    毕业论文关键词: 废水处理;A/O法;传统活性污泥法;
     Design Plan of Sewage Treatment Plant Capable of Handing 500 Thousand Tons
    The sewage treatment plant designed are built in the northeast of downtown Shanghai, it is mainly responsible for intercepting sewage from hongkou port and yangpu port area. The detailed design parameters of the sewage treatment plant are as follows:
    Daily processing sewage is 500 thousand tons; CODcr:250mg/L;BOD5:120mg/L;SS:150mg/L;TN:38mg/L;NH3-N :25mg/L;TP:4mg/L。
    Through the study and compare of the biological treatment technology, the treatment technology which combines A/O method and activated sludge method is adopted, which can achieve the purpose of nitrogen and organic matter degradation with low cost. The specific method of combination is using traditional activated sludge process to deal with seventy percent sewage, while thirty percent of wastewater by A/O process for processing.
    The design process is roughly as follows: The grating is to shut off the larger suspension or debris; The vortex grit chamber is to isolate inorganic particles whose density is relatively large from sewage, so as not to affect the normal operation of the subsequent processing structures, vortex grit chamber makes the sediment and organic matter apart and accelerate sand deposits by using  hydraulic eddy current; The biological pool which combine A/O and active sludge aeration tank is denitrification and phosphorus removal and degradation of organic pollutants in wastewater; The horizontal sedimentation is responsible for the separation of mixture of mud which is aerated, to ensure the final effluent water quality; The moisture content of sludge concentration pool is to reduce excess sludge, reduce sludge volume and reduce the cost of sludge transport.
  1. 上一篇:每天5000立米生物制药废水的处理工艺设计+CAD图纸
  2. 下一篇:日处理5万吨城镇生活污水的工艺设计+CAD图纸
  1. 镇江市某人工湖水体富营养化综合评价研究

  2. 某市新区污水处理厂设计+CAD图纸

  3. 日处理10000立方某纺织厂污...

  4. UASB+SBR某中药厂污水处理工程设计+CAD图纸

  5. 日处理5000立方米某染整废...

  6. 日处理1000立方米某味精厂...

  7. 日处理50万立方米城市自来水厂处理工艺设计

  8. 江苏省某高中学生体质现状的调查研究

  9. 中国传统元素在游戏角色...

  10. 巴金《激流三部曲》高觉新的悲剧命运

  11. 现代简约美式风格在室内家装中的运用

  12. C++最短路径算法研究和程序设计

  13. g-C3N4光催化剂的制备和光催化性能研究

  14. 上市公司股权结构对经营绩效的影响研究

  15. 高警觉工作人群的元情绪...

  16. 浅析中国古代宗法制度

  17. NFC协议物理层的软件实现+文献综述

  

About

优尔论文网手机版...

主页:http://www.youerw.com

关闭返回