菜单
  
    固体氧化物燃料电池(SOFC)是一种高效,环保的能量转换装置。随着能源和环境问题的日益严重,SOFC 的研究已经成为能源和材料领域的热点之一。   实验采用溶胶-凝胶法制备中温H2S固体氧化物燃料电池的电解质和阳极催化剂。电解质 Ce0.8Sm0.2O2(SDC)的 XRD结果表明经900℃煅烧后SDC 具有典型的萤石结构。400℃~800℃时,SDC 的电导率均随温度的升高而增大。 Y0.9Sr0.1Cr1-xFexO3(x=0.1, 0.3, 0.5)的测试结果表明经1000℃煅烧后,均形成典型的钙钛矿结构,且表面疏松多孔。同时具有良好的耐硫性和化学相容性。400℃~800℃时,电导率均随温度的升高而增大。综合分析选择 Y0.9Sr0.1Cr0.5Fe0.5O3作为阳极催化剂,组装成单电池YSCF-SDC|SDC|Ag。测试结果显示电池的性能随温度的增加不断提高。在 800℃,电池开路电压为0.91V,最大功率密度为12mW· cm-2最大电流密度 45 mA·cm-2关键词:H2S 固体氧化物燃料电池;中温;电解质;阳极6966
     Title   Synthesis and performance of anode materials for intermediate    
     temperature H2S solid oxide fuel cells    
    Abstract
    Solid oxide fuel cells (SOFCs) are efficient, green energy conversion devices. With the
    increasing energy crisis and environmental pollution,  SOFC has grabbed a lot of
    interests in energy and materials science.
    Electrolyte and anode catalysts of H2S solid oxide fuel cells were prepared by sol-gel
    method. The XRD  of Ce0.8Sm0.2O2 (SDC)  showed that  SDC has a  typical of  fluorite
    structure after calcining at 900℃. At 400℃~800℃,  the conductivities increased with
    the temperature.
    The results  of  Y0.9Sr0.1Cr1-xFexO3(x=0.1, 0.3,  0.5)  indicated that  fine powders with
    perovskite structure were obtained  after  calcining at  1000℃.  They also have  good
    resistance to sulfur and chemical compatibility.  At  400℃~800℃, the conductivities
    increased with the  temperature  at different atmospheres.  Y0.9Sr0.1Cr0.5Fe0.5O3  was
    chosen as the anode material. The electrochemical properties were measured for the
    cell with  configuration  of YSCF-SDC|SDC|Ag at different temperatures.  The results
    revealed the cell performance increased with the temperature rising. At 800℃, the open
    circuit voltage  was  0.91V;  the maximum power density and current density are
    12mW·cm-2and 45 mA·cm-2, respectively.
    Keywords: H2S Solid oxide fuel cells; Intermediate temperature; Electrolyte; Anode
    目录  
    1 绪论  .. 1
    1.1  燃料电池及应用   1
    1.1.1 燃料电池的工作原理 .  1
    1.1.2 燃料电池的特点   2
    1.1.3 燃料电池分类其应用 .  3
    1.2 H2S 固体氧化物燃料电池  .  4
    1.2.1 H2S 固体氧化物燃料电池研究背景及意义  ..  5
    1.2.3 H2S 固体氧化物燃料电池电解质研究进展  ..  7
    1.2.4 H2S 固体氧化物燃料电池阳极催化剂  .  8
    1.2.5 H2S 固体氧化物燃料电池阳极催化剂研究进展  .  10
    1.3 电池材料的制备方法  11
    1.3.1 固相烧结法   12
    1.3.2 微波合成法   12
    1.3.3 溶胶-凝胶(Sol-Gel)法  ..  12
    1.3.4 甘氨酸-硝酸盐法    12
    1.3.5 尿素燃烧法   13
    1.4 本课题的主要研究内容 ..  13
    2 SDC的制备及表征 14
    2.1  实验部分 .  14
    2.1.1  实验药品及仪器   14
    2.1.2 SDC 的制备    14
    2.1.3 SDC 的表征方法  .  15
    2.2 结果与讨论 .  17
  1. 上一篇:分光光度法快速测定工业废水中金属离子镍和锌含量的方法研究
  2. 下一篇:金属-有机骨架材料MOF-5合成及CO2吸附性能研究
  1. 固体酒精的制备工艺研究

  2. 阳极集流件对管式固体氧...

  3. Sr-Ti-O固体催化剂的制备

  4. Li6.42La2.98Ba0.02Zr1.55W0.35Y0...

  5. 复合结构的高能固体推进剂探索研究

  6. 固体推进剂的热稳定性分析

  7. 制备Sn-Fe-O固体催化剂

  8. 上市公司股权结构对经营绩效的影响研究

  9. 现代简约美式风格在室内家装中的运用

  10. NFC协议物理层的软件实现+文献综述

  11. 中国传统元素在游戏角色...

  12. 巴金《激流三部曲》高觉新的悲剧命运

  13. C++最短路径算法研究和程序设计

  14. 浅析中国古代宗法制度

  15. 高警觉工作人群的元情绪...

  16. 江苏省某高中学生体质现状的调查研究

  17. g-C3N4光催化剂的制备和光催化性能研究

  

About

优尔论文网手机版...

主页:http://www.youerw.com

关闭返回