菜单
　　
    摘要本文用PAC与P(AM-DAC)作为絮凝剂用于双组份模拟印染废水的絮凝研究进行初步探索。以吸光度和Zeta电位为考察指标，对由活性红和活性黑两种活性染料组成0:1,1:3，1:1，3:1和1:0的五种配比模拟印染废水做絮凝脱色研究。探索无机和有机絮凝剂对不同活性染料组成的双组份模拟印染废水絮凝脱色效果及机理推测。无机絮凝剂PAC处理五种配比的混合溶液，活性红染料的最大脱除率分别为98.6%，99.2%,97.5%,96.5%和0,活性黑的最大脱除率分别为0，89.4%，91.9%，93.4%和92.9%。有机絮凝剂P（AM-DAC）处理五种配比的混合溶液，活性红染料的最大脱除率分别为41.1%，65.0%，90.0%，96.7%和0，活性黑的最大脱除率分别为0，0，6.6%，29.0%和53.2%。结果表明，PAC的最大脱除率高于P(AM-DAC)；PAC对活性红组分的絮凝脱色效果优于活性黑组分；当使用P(AM-DAC)絮凝时，活性黑组分将会在活性红组分几乎完全絮凝沉淀后才会开始絮凝。以上研究实验为双组份染料废水絮凝脱色研究和机理探索提供了基础和方向。19048
    关键词  双组份 活性染料 絮凝脱色 PAC P(AM-DAC)
    毕业设计说明书（论文）外文摘要
    Title  The research of two-component dye wastewater flocculating decoloration mechanism
    Abstract 
    Preliminary flocculation research of a two-component simulation of dyeing wastewater was carried out by using PAC and P(AM-DAC) as a flocculant. Using absorbance and Zeta potential as criterions，a flocculating decoloring was be done on five kinds of the two-component simulated with different mass ratio: 0:1,1:3，1:1，3:1 and 1:0 dyeing wastewater  composed of  reactive red dye and reactive black. The decoloring effect of inorganic and organic flocculants on the two-component simulation of dyeing wastewater were researched. By using PAC as flocculent, the most removal rate of reactive red were 98.6%，99.2%,97.5%,96.5% and 0.The most removal rate of reactive black were 0，89.4%，91.9%，93.4% and 92.9%. By using P(AM-DAC) as flocculent, he most removal rate of reactive red were 41.1%，65.0%，90.0%，96.7% and 0. The most removal rate of reactive black were 0，0，6.6%，29.0% and 53.2%. As the result showed, he most removal rate of reactive red was higher than The most removal rate of reactive black; The flocculation effect of reactive red is better than reactive black  flocculated when by using PAC; By using P(AM-DAC) as flocculent, the reactive black component will be flocculated until reactive red had been flocculated completely. The above research results provided the basis and direction of two-component dye wastewater flocculating decoloring research and mechanism exploration.
    Keywords   Two-component   Reactive Dyes   PAC   P(AM-DAC)
    目    录
    1    绪论 1
    1.1常见的印染废水处理方法 1
    1.2现阶段存在问题   3
    1.3染料的选择及其结构特点  4
    2絮凝原理   6
    2.1絮凝基本原理   6
    2.2溶性染料废水絮凝基本原理    6
    3实验方案设计    7
    3.1设计思路 7
    3.2研究路线工作图 8
    4实验仪器和药品 9
    4.1实验仪器和药品 9
    4.2实验基本步骤 10
    4.2.1药剂及模拟印染废水配制 10
    4.2.2水质分析方法及基本絮凝实验条件确定10
    4.2.3絮凝剂对模拟废水处理实验11
    4.3实验结果11
    4.3.1  最大吸收波长测定11
    4.3.2  使用PAC作为絮凝剂的初步探索 14
    4.3.3使用P（AM-DAC）作为絮凝剂的初步探索 15
    4.3.4  多组份染料溶液浓度的分析方法 15
    4.3.5  Zeta电位 22
    4.4问题讨论24
    结论 25
    致谢 26
    参考文献27
     1  绪论
         棉、毛、化纤等纺织产品在预加工、染色、印花和整理过程中所排放的废水叫做印染废水，大量产生于工业生产中。印染废水所含物质复杂，芳烃以及杂环化合物为主体，并带有极性和显色基团，还含有起促进染色作用的助凝剂。印染废水的水量总大、COD浓度高、色度高、含多种具有毒性的有机物成分，有较强的抗氧化性、抗生物降解性，已经污染全国各大水域。由于印染废水COD高，而且B/C 值较小，生化性较差；色度高而且组分复杂[1]。
  1. 上一篇：水滑石基CO2吸附剂的制备与性能测试
  2. 下一篇：新型铈基氧化物NH3-SCR催化剂的改进

  1. PS-b-PHEMA及其双组分嵌段共...

  2. PS-b-PNIPAM单组份及其双组份...

  3. ZnGa2O4光催化材料的制备及...

  4. MoS2/TiO2纳米管阵列电极在...

  5. 活性炭-微波辐照水中染料酸性红B的研究

  6. 合成手性有机催化剂五元双环胍的新方法

  7. 有机双光子线粒体内活性...

  8. 江苏省某高中学生体质现状的调查研究

  9. g-C3N4光催化剂的制备和光催化性能研究

  10. 巴金《激流三部曲》高觉新的悲剧命运

  11. 高警觉工作人群的元情绪...

  12. C++最短路径算法研究和程序设计

  13. 浅析中国古代宗法制度

  14. 现代简约美式风格在室内家装中的运用

  15. 中国传统元素在游戏角色...

  16. NFC协议物理层的软件实现+文献综述

  17. 上市公司股权结构对经营绩效的影响研究

　　

About

优尔论文网手机版...

主页：http://www.youerw.com

关闭返回