8。Additional Materials Information

The density of the material is 2680 kg/m3。

9。Quality

9。1。Castings shall conform to the quality, certification and identification requirements issued by Purchaser’s Quality Assurance function for the appropriate part number。

9。2。Castings shall be uniform in quality and condition, sound and free from foreign materials and from internal and external defects detrimental to fabrication or to performance of parts。 Castings shall have smooth surfaces and shall be well cleaned。

9。3。Porosity

9。3。1。Castings that contain latent foundry defects, which have been accepted, may be rejected after machining if the machining operation exposes porosity or other defects that affect the performance of the finished part。

Turbo Technologies NUMBER IDM-4234

REVISION

NTITLE

MATERIALS SPECIFICATION CAST ALUMINUM ALLOY – 356-F BY

Ondrej BojdaDATE

12/02/11 Page6 of 8

9。3。2。Radiographic and other quality standards shall be as agreed upon by vendor  and Honeywell Turbo Technologies。

9。3。3。Castings shall be produced under radiographic control。 This shall consist of radiographic examination of castings until proper foundry technique, which will produce castings free from harmful internal defects, has been established for each mould and of production castings as necessary to ensure maintenance of satisfactory quality。

9。4。Casting Repair

9。4。1。Castings shall not be repaired by plugging, welding or other methods without written approval from the Honeywell Turbo Technologies。 Any weld repair shall conform to the applicable weld repair specification。

9。4。2。Castings shall not be impregnated, chemically treated or coated unless authorized in writing by Honeywell Turbo Technologies。 If impregnation is approved the applicable specification shall be used。

9。5。Retesting

If initial test results fail to meet requirements and material is re-tested, such re-tests must be carried out per QCI-9310-175。

9。6。Identification

Specified castings shall be identified in accordance with the engineering drawing and in accordance with PI-5780。

10。Reports

10。1。Unless otherwise specified, the supplier shall retain at their facility the results of tests that determine conformance of the parts to the requirements of this specification。 Evidence of such is to be on file for examination for a period of five years from the date of shipment。

10。2。The reports shall show the chemical composition, mechanical properties, microstructure, material specification number (IDM and international material designation) and revision letter, purchase order number and quantity。 Honeywell Turbo Technologies reserved the right to perform tests to verify that the material meets the requirements and to reject non-conforming material。

Turbo Technologies NUMBER IDM-4234

REVISION

NTITLE

MATERIALS SPECIFICATION CAST ALUMINUM ALLOY – 356-F BY

Ondrej Bojda DATE

12/02/11 Page7 of 8

11。Equivalent Materials

11。1。The materials listed below are equivalent to the material described in this specification and may be used interchangeably provided that the technical requirements of this specification are met。 However, the lead (Pb) content shall not exceed that specified in 6。1。1。

11。2。This table is not an exhaustive list of equivalent materials; other equivalent materials may be used provided that the proposal is acceptable to a competent person within the Materials Engineering Group and that the technical requirements of this specification are met。 Such alternatives shall be explicitly documented as per the requirements in paragraphs 1。4 and 10。2 of this specification。